You are looking at a brand new, in box pool heater, not reconditioned, not rebuilt. Now you can use your in ground or large above ground pool even when its not swimming season. You can begin your pool season months early and close months later. ++this heater uses as much electricity as an electric water heater but produces 6 times the heat.
(26 amps at 220 volts). It is a 109,000 btu capacity heater, large enough to heat an above ground pool up to 30′ round, 18 x 43 oval; or an in ground pool of upto 25,000 gallons. This figure is approximated, based on air temperature and humidity. As a note, the higher the humidity, the higher the performance. ++installation is very easy, about 20 minutes all together.
The system runs on a 30 amps 220 volts circuit, which is a 10 gauge wire on a dedicated circuit. It will not run on 110 volts.
This unit is 220 only. The connections are compression fittings, 1 1/2 pipe. The controls and display is built in, digital with a polycarbonate weatherproof cover. Also supplied with a reduntant flow switch to prevent meltdowns caused by single malfunctioning flow switches. If you’d like to install the controls away from the heater, we do stock extender cables, available at 25 dollars, for 25 feet.
The compressor is of scroll type, made by sanyo. Heat exchanger is made of titanium. Case is white, enamel coated steel case. The floor of the unit is combination of galvanized/stainless steel.
It is a product of fibropool company. Deliveries should be made to a business location with loading dock/ ramp or forklift; or you can pick the unit up from the truck carrier’s terminal. If you live in these states, there will be a 32.00 dollars fuel surcharge. You can pick the units up from our supplier’s warehouse in bay saint louis, ms.
Which is 45 miles east of new orleans, la. Folcroft pa; 10 minutes south of philadelphia. An rga (returned goods authorization) number must be obtained first.
