Patent Pending Application # 61679058. New Features for 2016 Model WaveHeater. Flow switch that disconnects power through GFCI load center. High temperature air vent removes unwanted air from element housing. Safe plastic design that integrates with pool filtration system. Kw heating element with heavy duty booting. 2 male adapters thread on to Intex lines and others! The 120 VAC WaveHeater is a 2000 watt pool heater for use with above ground swimming pools 3000 gallons or less. The 120 vac WaveHeater provides 6824 BTU’s of heating power. Because of the plastic design, the unit is able to lie in wet areas next to the pool and operate safely without the corrosion and current leakage issues of metal units. It is manufactured to be installed in line between the existing pool pump and pool inlet. The 120 vac WaveHeater requires a 20 amp dedicated GFCI outlet. The “WaveHeater” also incorporates a high temperature air vent to purge any unwanted entry of air from the system. Pools heat slowly and require insulated covering for best results. Successful heating directly corresponds to pool cover insulation and outside temperature. If there is a component failure during that period, a new part will be sent at no cost to the customer. What is not covered. Any and all overheat damage or destruction to the WaveHeater or components due to improper wiring. The item “WAVEHEATER ELECTRIC POOL HEATER 3000 GAL MAX, PLUGS IN! WATERPROOF” is in sale since Tuesday, June 07, 2016. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Equipment & Parts\Pool Heaters & Solar Panels”. The seller is “davidthefix-itguy” and is located in Snohomish, Washington. This item can be shipped to United States.
- Power Source: Electric
- Brand: WaveHeater
- Material: PLASTIC
- Model: AGPH2000W
- Country/Region of Manufacture: United States
THE WAVEHEATER IS THE ONLY ELECTRIC HEATER SPECIFICALLY MANUFACTURED FOR ABOVE GROUND POOLS! THE PLASTIC CASING MEANS NO CORROSION AND NO CURRENT LEAKAGE. HEAVY DUTY ELECTRICAL BOOTING AND SOLID ELECTRICAL CONNECTIONS IN ADDITION TO THE ALL PLASTIC CASING MAKE IT EVEN SAFER! THEREFORE THE UNIT CAN BE INSTALLED WITH CONFIDENCE BETWEEN PUMP AND POOL!!! GFCI load center is an example and is not included with WaveHeater package. PLEASE READ TECHNICAL INFORMATION CAREFULLY! Patent Pending Application # 61679058. Above Ground Pools are going up all over America with the same result… The consumer goes to much trouble and expense to install and fill the new pool. Then the kids stick their toes in and utter the fateful words… IT’S TOO COLD!! ” People try solar covers and various other solar products, but unless they live in the desert, that pool is gonna stay “TOO COLD. Well, here’s the answer!! –The “WaveHeater” for above ground pools. With normal summer temperatures, the “WaveHeater” can “Safely and Effectively” keep your pool a comfortable temperature! New Features for 2016 Model WaveHeater. Flow switch that disconnects power through GFCI load center with quicker installation as well as increased protection against overheat! High temperature air vent removes unwanted air from element housing. Safe plastic design that integrates with pool filtration system. 5.5kw heating element with heavy duty booting. 2 male adapters thread on to Intex lines and others! The WaveHeater is a 5500 watt pool heater for use with above ground swimming pools under 8000 gallons. The WaveHeater provides 18770 BTU’s of heating power. Because of the plastic design, the unit is able to lie in wet areas next to the pool and operate safely without the corrosion and current leakage issues of metal units. It is manufactured to be installed in line between the existing pool pump and pool inlet. The WaveHeater requires a 240 VAC, 30 amp power source as well as a 30 amp gfci sub-panel. Power from the gfci sub-panel to the WaveHeater must be in 3/4 liquid tight conduit. The 2015 “WaveHeater” model uses a flow switch to protect the unit against overheat. The “WaveHeater” also incorporates a high temperature air vent to purge any unwanted entry of air from the system. 4000 to 8000 gallon pools heat slowly and require insulated covering for best results. Successful heating directly corresponds to pool cover insulation and outside temperature. If there is a component failure during that period, a new part will be sent at no cost to the customer. What is not covered. Any and all overheat damage or destruction to the WaveHeater or components due to improper wiring. The item “THE 2016 WAVEHEATER ELEC. HEATER FOR ABOVE GROUND POOLS 5.5kw 18770 btu’S” is in sale since Thursday, March 03, 2016. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Equipment & Parts\Pool Heaters & Solar Panels”. The seller is “davidthefix-itguy” and is located in Snohomish, Washington. This item can be shipped to United States, to Canada.
- Brand: PMPH
- MPN: PMPH1001-1
- Material: Plastic
- Power Source: Electric
- Model: AGPH5500W
- Country/Region of Manufacture: United States
The WAVEHEATER for above ground pools is a 5500 watt pass-through water heater, for use with above ground swimming pools under 8000 gallons. Because of the plastic design, the unit is able to lie in wet areas next to the pool and operate safely without the corrosion and current leakage issues of metal units. It is manufactured to be installed inline between the existing pool pump and pool inlet. The WAVEHEATER requires a 240 vac, 30 amp power source as well as a 30 amp gfci load center. Power from the gfci load center to the WAVEHEATER must either be in 3/4 liquid tight conduit. The WAVEHEATER uses a pressure switch to protect the unit if flow stops. The WAVEHEATER also incorporates a high temperature air vent to purge any unwanted entry of air from the system. 4000 to 8000 gallon pools heat slowly and require insulated covering for best results. Successful heating directly corresponds to pool cover insulation and outside temperature. Safe plastic design allows unit to be installed between filter pump and pool. Pressure switch an high temp air vent keep unit safe in case of accidental loss of flow. WaveHeater provides 18770 BTU’S per hour of heating power. 20 x 12 x 8 inches ; 8.6 pounds. The item “WaveHeater (Electric pool heater) for above ground pools” is in sale since Tuesday, September 08, 2015. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Parts & Maintenance\Pool Heaters & Solar Panels”. The seller is “easyshopper7″ and is located in Edinboro, Pennsylvania. This item can be shipped to United States.
- Brand: PMPH
- MPN: PMPH1001
- Model: AGPH5500W
- Country/Region of Manufacture: United States
Patent pending application # 61679058. Above ground pools are going up all over america with the same result… The consumer goes to much trouble and expense to install and fill the new pool. Then the kids stick their toes in and utter the fateful words… ” people try solar covers and various other solar products, but unless they live in the desert, that pool is gonna stay “too cold. Well, here’s the answer!! –the “waveheater” for above ground pools. With normal summer temperatures, the. Can “safely and effectively” keep your pool a comfortable temperature! Features for 2015 model. Pressure switch that disconnects power through gfci load center. High temperature air vent removes unwanted air from element housing. Safe plastic design with heavy duty booting for use with pool filtration system. 2 male adapters thread on to intex lines and others! For above ground pools is a 5500 watt pass through water heater for use with above ground swimming pools under 8000 gallons. Because of the plastic design, the unit is able to lie in wet areas next to the pool and operate safely without the corrosion and current leakage issues of metal units. It is manufactured to be installed inline between the existing pool pump and pool inlet. The wave heater requires a 240 vac, 30 amp power source as well as a 30 amp gfci sub-panel. Power from the gfci sub-panel to the. Must either be in liquid tight conduit. Pressure switch to protect the unit against overheat. Also incorporates a high temperature air vent to purge any unwanted entry of air from the system. 4000 to 8000 gallon pools heat slowly and require insulated covering for best results. Successful heating directly corresponds to pool cover insulation and outside temperature.The item “THE WaveHeater (Electric pool heater) p/n PMPH1001″ is in sale since Monday, April 13, 2015. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Parts & Maintenance\Pool Heaters & Solar Panels”. The seller is “davidthefix-itguy” and is located in Snohomish, Washington. This item can be shipped to United States.
- Brand: PMPH
- Model: AGPH5500W
- MPN: PMPH1001
- Country/Region of Manufacture: United States